Riverstone Networks WICT1-12 Spezifikationen PDF herunterladen (Seite 33)

Riverstone Networks RS 2100 Switch Router Getting Started Guide 2-11

RS 2100 Introduction Hardware Overview

LEDs

The gigabit ports use the following LEDs.

Table 2-6 Gigabit port LEDs

LED Description

Per-port Link Green – Indicates that the port hardware detects a cable plugged into the port

and a good link is established.

Red (intermittent) – Indicates that the port received an error during

operation.

Red (solid) – Indicates that the port hardware detects a cable plugged into the

port, however, a bad link is established.

Off – Indicates that no link from exists with the port.

Per-port Rx Green – Indicates when the port’s transceiver receives packets.

Orange – Indicates when the port’s transceiver receives flow-control packets.

Per-port Tx Green – Indicates when the port’s transceiver transmits packets.

Orange – Indicates when the port’s transceiver transmits flow-control

packets.

Per-port AN Green – Indicates that the gigabit port is autonegotiating the operating mode

of the link between full-duplex and half-duplex.

Orange (intermittent) – Indicates that autonegotiation is in process.

Orange (solid) – Indicates a problem with autonegotiation configuration.

Red – Indicates an autonegotiation failure. This fault may occur if the link

partner does not support full duplex.

Off – Indicates that autonegotiation has been disabled or the link is down.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 76 77

Keine Kommentare

Riverstone Networks WICT1-12 Spezifikationen Seite 33