Riverstone Networks WICT1-12 Spezifikationen PDF herunterladen (Seite 62)

3-12 Riverstone Networks RS 32000 Switch Router Getting Started Guide

Installing the Hardware Hardware Installation

To install the Control Module preform the following steps:

1. If a cover plate is installed in the Control Module slot (slot number CM/8 or CM/9), remove the

cover plate: loosen the screws on the ejectors until the screws pop out, then open the ejectors and

pull out the plate.

2. Open the ejectors at the top and bottom of the Control Module.

3. Align the backsheet of the Control Module with the card guides at the top and the bottom of the slot

opening, as shown in Figure 3-6.

Warning Make sure that the backsheet (metal plate) of the Control Module and not the

circuit card is between the card guides. Check both the upper and lower

tracks.

4. Slide the Control Module all the way into the slot, firmly but gently pressing to ensure that the pins

on the back of the Control Module are completely seated in the backplane.

5. To lock the Control Module into the slot, close the ejectors. Using a straight-blade screwdriver,

tighten the screw on each ejector.

6. When you are ready to attach the management cables to the Control Module, use the procedures in

"Attaching the Control Module Management Cables."

Installing PC Flash Cards in the Control Module

The Control Module 16 megabyte PC flash card contains the system image software.

To install the PC flash card into the Control Module, perform the following steps:

1. Make sure the power is off on the RS 32000. You cannot install or remove a PC card while the

RS 32000 is running.

2. Insert the PC card into either of the slots on the Control Module. You can choose either slot.

Note The RS 32000 supports the use of dual PC cards, one in slot0, the other in slot1.

Each PC card is treated as an independent file system by the RS 32000. For

detailed information regarding the PC flash file system and the management of

configuration files, see the “Riverstone RS Switch Router User Guide.”

3. Lock the PC card into the slot by pushing the PC card all the way into the slot (see Figure 3-7).

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 110 111

Keine Kommentare

Riverstone Networks WICT1-12 Spezifikationen Seite 62