Riverstone Networks WICT1-12 Spezifikationen PDF herunterladen (Seite 63)

Riverstone Networks RS 32000 Switch Router Getting Started Guide 3-13

Hardware Installation Installing the Hardware

Figure 3-7 Installing PC flash memory card

Note If the message “SYS-E-NOFLASHCARD” appears while booting the RS 32000, the

system has not detected a PC card. If this occurs, ensure that the PC card is

properly inserted, then reboot. If the system still does not recognize the card,

contact Riverstone Networks, Inc. technical support.

Attaching the Control Module Management Cables

The Control Module has two ports for attaching management devices to the RS 32000.

• A male DB-9 DCE port for direct serial connection from a terminal or PC running terminal

emulation software. Use this port to perform basic setup, including setting up the RS 32000 for

management through the Control Module’s RJ-45 Ethernet port.

• An RJ-45 10/100Base-T DTE port for Telnet connection from a host on the network. The port is

configured for Media Data Interface (MDI). You use this port to manage the RS 32000 using a Telnet

session or SNMP-based management software.

PC Card

Card Ejector Out

Insert Card

Card

Ejectors

Out

Card

Ejectors

Card Inserted,

Card Ejector Pushed In

Push Card Ejector,

Then Ejector Pops Out

Card Ejector Pushed In,

Card Is Ejected

Slot

Empty

PC Card

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 110 111

Keine Kommentare

Riverstone Networks WICT1-12 Spezifikationen Seite 63