Riverstone Networks WICT1-12 Spezifikationen PDF herunterladen (Seite 85)

Riverstone Networks RS 32000 Switch Router Getting Started Guide 4-19

Initial Configuration Setting the DNS Domain Name and Address

4.7 SETTING THE DNS DOMAIN NAME AND

ADDRESS

Associating a DNS name server with your RS 32000 allows you to use device names (rather than IP addresses) when

entering certain commands. For example, you can use a device’s name (which the DNS server knows) when using the

ping command.

If you want the RS 32000 to access a DNS server, use the following procedure to specify the domain name and IP

address for the DNS server.

1. Ensure that you are in Enable mode by entering the enable command in the CLI.

2. Use the ping command to verify that the RS 32000 can reach the DNS server.

Here is an example:

3. Enter Configure mode by entering the configure command in the CLI.

4. Enter the following command to specify the domain name for which the DNS server(s) have

authority:

For example: <domain-name> =

riverstone.com

Enter the following command to add the DNS server to the RS 32000:

where <IP-addr> is the IP address of the DNS server(s). You can specify up to three DNS servers. Separate the

server IP addresses with commas.

6. Enter the save active command to activate the commands and enter yes to activate the changes.

Here is an example:

rs# ping 16.50.11.12 <IP address of the DNS server>

PING 16.50.11.12 (16.50.11.12): 56 data bytes

64 bytes from 16.50.11.12: icmp_seq=0 ttl=255 time=0 ms

--- 16.50.11.12 ping statistics ---

1 packets transmitted, 1 packets received, 0% packet loss

round-trip min/avg/max = 0/0/0 ms

system set dns domain <domain-name>

system set dns server <IP-addr>[,<IP-addr>[,<IP-addr>]]

rs#

config

rs(config)# system set dns domain "mktg.mrb.com"

rs(config)# system set dns server 16.50.11.12

rs(config)# save active

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 110 111

Keine Kommentare

Riverstone Networks WICT1-12 Spezifikationen Seite 85